Source Name; Service - Martin Logan Verse Manuel De L'utilisateur

• Next Input
• Previous Input
• Up
• Down
• Left
• Right
• Enter
• Bass Mode: Night
• Bass Mode: Normal
• Bass Mode: Bass+
• Stereo Mode: Wide
• Stereo Mode: Voice+
• Stereo Mode: Normal
• Power Toggle
• Power On
• Power Off
• Menu
• Input: Bluetooth
• Input: Optical 1
• Input: Optical 2
• Input: Analog 1
• Input: Analog 2
• ARC On [Anthem Room Correction On]
• ARC Off [Anthem Room Correction Off]
Choose the command you want to program and
press the enter button. The soundbar will respond
with 'Push Button'. Hold the second remote approx-
imately 12 inches (30cm) from the soundbar and
press the appropriate button four times. If the
new command is learned successfully, the sound-
bar's display will display "Saved". If the new
command is not learned, the soundbar will display
"Failed". Repeat the process if learning fails.
Learn Remote > Reset Remote: Enter the
submenu by pressing the enter button. Resetting
will clear programming for the second remote. The
Reset function requires confirmation.
Learn Remote > Reset Remote > No: Activate
by pressing the enter button. Choosing this option will
exit without erasing the remote programming.
Learn Remote > Reset Remote >Yes:
Activate by pressing the enter button. The soundbar
will respond with 'Resetting'. After codes are reset,
there is no way to recover the previous settings.
MENU OPTION: SOURCE NAME
Source Name: Enter the submenu by pressing
the enter button. The settings in this menu will allow
you to assign new names to display on the sound-
bar when changing inputs. For example, you can
program the 'Optical 1' input to display 'DVD'.
Using the up/down directional buttons, you can
select and program the following input names:
• Optical 1
• Optical 2
Choose the input name you want to reprogram and
press the enter button. The soundbar display will
display the current name. Pressing the up/down
directional buttons will cycle through the available
alpha-numeric characters. Pressing the left/right direc-
tional buttons will move to the next/previous space.
To finish programming an input name, use the left/
right buttons to move all the way to the left or right.
MENU OPTION: SERVICE
Service: Enter the submenu by pressing the enter button.
Service > Firmware: Enter this submenu by
pressing the enter button.
Service > Firmware > MCU: Pressing the
enter button will display the current firmware ver-
sion for the soundbar MCU (microcontroller unit).
Service > Firmware > DSP: Pressing the
enter button will display the current firmware ver-
sion for the soundbar's DSP module.
• Analog 1
• Analog 2
27