Anthem Room Correction; Power Settings - Martin Logan Verse Manuel De L'utilisateur

soundbar's display to be on at a reduced bright-
ness when the soundbar is on. Activate by
pressing the enter button and the soundbar will
respond with 'Saved'.
Display > Auto Bright: This option configures
the soundbar's display to be on at full bright-
ness when a setting (such as volume or input) is
changed. After a few seconds, the display will turn
off. Activate by pressing the enter button and the
soundbar will respond with 'Saved'.
Display > Auto Dim: This option configures
the soundbar's display to be on at a reduced
brightness when a setting (such as volume or input)
is changed. After a few seconds the display will
turn off. Activate by pressing the enter button and
the soundbar will respond with 'Saved'.
MENU: ANTHEM ROOM CORRECTION
Anthem Room Correction: Enter the sub-
menu by pressing the enter button. Here you
may turn Anthem Room Correction on and off.
Using proprietary processes, a microphone, and
the power of your PC, the ARC system analyzes
your soundbar's in-room sound, then computes the
required correction to yield optimal performance
within your acoustic environment.
Anthem Room Correction > Off or On:
This option turns the Anthem Room Correction
feature on or off. Activate by pressing the enter but-
ton and the soundbar will respond with 'Saved'.
Please note, turning ARC on and off only makes a
difference if ARC corrections have not been load-
ed on the soundbar.
MENU OPTION: POWER SETTINGS
Power Settings: Enter the submenu by press-
ing the enter button. Here you may adjust how the
soundbar's power options.
Power Settings > Power Standby: Enter
the submenu by pressing the enter button. Here
you choose whether the subwoofer is always on or
turns itself on and off automatically.
Power Settings > Power Standby > Auto
Standby: This option configures the soundbar to
turn itself off after no audio signal is detected for
approximately 20 minutes. When the soundbar
detects an audio signal, it will immediately turn
itself on. Activate by pressing the enter button and
the soundbar will respond with 'Saved'. Please
note: When set to Auto Standby, if the soundbar is
manually turned off (using the power button on the
control panel or remote control), the soundbar will
not respond to an incoming audio signal and will
not turn on automatically. In this situation, turn the
soundbar on using the power button on the con-
trol panel or remote control and the soundbar will
resume automatic power handling.
Power S et tings > Pow er S tand by
> Always On: This option configures the
soundbar to remain on at all times until it is
manually turned off using the power button
on the control panel or remote control. Activate
by pressing the enter button and the soundbar will
respond with 'Saved'.
Power Settings > Power-On Volume: Enter
the submenu by pressing the enter button. Here you
can configure the default volume of the soundbar
when it powers on or comes out of standby.
Power Settings > Power-On Volume >
Set: Enter the submenu by pressing the enter but-
ton. Here you choose set the power-on volume.
Power Settings > Power-On Volume >
Set > –90dB to +10dB: Using the up/down
25