Automatic Component Protection; Using The Remote Control - Friedrich WallMaster WS08 Manuel D'installation Et D'utilisation

Figure 1: WS Model cool-only control panel

Automatic component protection

Your unit is equipped with Automatic Component Protection.
To protect the compressor of the unit, there is a three minute delay
if you turn the unit off or if power is interrupted. The fan will not be
affected. Also, if you switch from Cool mode to Fan Only mode, and
switch back to Cool mode, there is a three-minute delay before the
compressor comes back on.

Using the remote control

To start unit
1 POWER - Press the Power button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the operat-
ing mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run the
fan only.
4
HEAT (WY/WE models only) - Press the Heat button to
automatically switch the operating mode to HEAT.
5 MoneySaver - Press the Money Saver
®
the MoneySaver feature. This feature cycles the fan with the
®
compressor so that the fan does not run all the time.
920-007-14
button to activate
®
PM
2 3 4
8
Fan
Smart
9
Speed
Fan
Money Timer
14
Saver On/Off
13
10 11 12
Figure 2: WY/WE Model heat-cool control panel
To adjust temperature
6 WARMER - Press the
7 COOLER - Press the
To adjust fan speed
8 FAN SPEED - Press the Fan Speed button to see the current
setting. Press again to change the fan speed. F1 is the lowest
setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is
the SMART FAN setting.
To set the hour clock
9 SET HOUR CLOCK - Press the Set Hr. button once to see the
current clock setting. Continue pressing the button until you
arrive at the current time (Hour only). Minutes are not shown on
the display. Make sure that the A.M. / P.M. setting is correct.
Power
Cool
Fan Only
Mode
Heat
Clock
Set
Start Time
Hour
Stop Time
Temp/Hour
Warmer button to raise the temperature setting.
Cooler button to lower the temperature setting.
1
6
7
5
5