To Adjust Temperature; To Adjust Fan Speed; To Activate Smart Fan; To Set Hour Clock - Friedrich XSTAR Série Guide D'utilisation

How to operate your friedrich room air conditioner (continued)

To adjust temperature

4 Use the MODE button to select either the COOL or
MoneySaver ® function
5 COOLER – Touch the downward-pointing triangle
with the minus symbol, (
temperature.
6 WARMER – Touch the upward-pointing triangle
with the plus symbol (
temperature.
7 Press both the
switch the temperature from Fahrenheit (°F) to Celsius
(°C).
Repeat step 7 to switch from °C back to °F.

To adjust fan speed

8 Touch the FAN SPEED button to see the current
setting. Touch it again to change speed. F1 is the
lowest setting (SLEEP SETTING / LOW,) F2 is
MEDIUM, and F3 is HIGH.

To activate Smart Fan

9 There is a fourth option, SF, when selecting the fan
speed. This is the SMART FAN function. SMART
FAN DOES NOT OPERATE IN CONJUCTION
WITH THE FAN ONLY MODE.
Smart Fan will adjust the fan speed automatically to
maintain the desired comfort level. For example, if the
outside doors in your home are opened for an extended
period of time, or more people enter a room, Smart Fan may
adjust to a higher fan speed to compensate for the increased
heat load. This keeps you from having to adjust the fan
speed on your own.
To set the hour clock
10 Touch the SET HOUR button to see the current setting.
The number that is displayed is the approximate time
(hour only). Use the two triangle-shaped buttons (
and ) to change the settings. BE SURE TO SET
A.M. AND P.M. ACCORDINGLY. (P.M. is indicated
by a red light in the upper left corner of the display.)
) to lower the room air
) to raise the room air
and at the same time to

To set the timer

NOTE: Set the HOUR CLOCK before attempting to set
timer functions.
You can set the START and STOP times a minimum of one
hour apart, and a maximum of twenty-three hours apart.
11 After setting the time, press the SET HOUR button
once (Start light on.) Use the two triangle-shaped
buttons ( and
will START.
12 After selecting the START time, press the SET HOUR
button once. (Stop Light on.) Use the two triangle-
shaped buttons (
the unit will STOP. After selecting the stopping time,
press the SET HOUR button once.
13 Press the TIMER ON / OFF button (light turns on) to
activate the timer function. To deactivate this function,
press the TIMER ON / OFF button once again (light
turns off.) Once the on and off times have been
selected, they will remain in memory and cycle daily
until changed.
NOTE: If the unit is unplugged or the power is interrupted,
the HOUR must be reset or the TIMER ON / OFF will not
function when desired.

Automatic component protection

Your unit is equipped with Automatic Component
Protection.
To protect the compressor of the unit, there is a three minute
delay if you turn the unit off or if power is interrupted. The
fan will not be affected. Also, if you switch from COOL
mode to FAN ONLY, and switch back to COOL mode,
there is a three minute delay before the compressor comes
back on.
) to select the time that the unit
and ) to select the time that
5