Automatic Component Protection; Using The Remote Control - Friedrich WallMaster Serie Manuel D'installation Et D'utilisation

Digital Control Panels
Figure 1:
WS Model cool-only control panel
Figure 2:
WY/WE Model heat-cool control panel

Automatic component protection

Your unit is equipped with Automatic Component Protection.
To protect the compressor of the unit, there is a three
minute delay if you turn the unit off or if power is
interrupted. The fan will not be affected. Also, if you switch
from Heat/Cool mode to Fan Only mode, and switch back to
Heat/Cool mode, there is a three-minute delay before the
compressor comes back on.

Using the remote control

To start unit (See Figure 3, page 6)
1
POWER - Press the Power button once. The unit will
automatically start in the mode and fan speed it
was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the
operating mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run
the fan only.
HEAT (WY/WE models only) - Press the Heat button to
4
automatically switch the operating mode to HEAT.
MoneySaver® - Press the Money Saver® button to
5
activate the MoneySaver® feature. This
feature cycles the fan with the compressor
so that the fan does not run all the time.
To adjust temperature
WARMER - Press the
6
temperature setting.
7 COOLER - Press the
temperature setting.
Note: Your remote control will only operate in Fahrenheit (°F)
To adjust fan speed
8 FAN SPEED - Press the Fan Speed button to see the
current setting. Press again to change the fan
speed. 1 is the lowest setting (SLEEP / LOW),
2 is MEDIUM, 3 is HIGH, and
FAN setting.
To reset Check Filter light
Check Filter Reset - Press the Check Filter button to reset
9
the filter timer and turn off the Check
FIlter light.
To set the hour clock
SET HOUR CLOCK - Press the Set Hour button once to see the
10
current clock setting. Continue pressing the button until arrive
at the current time (Hour only). Minutes are not shown on the
display. Make sure thaat the A.M/P.M setting is correct.
Warmer button to raise the
Cooler button to lower the
is the SMART
5