To Adjust Temperature; To Adjust Fan Speed; To Activate Smart Fan; To Set Hour Clock - Friedrich WallMaster WS08 Instructions D'installation Et D'utilisation

To adjust temperature

4
Use the Mode button to select either the Cool or MoneySaver
function
5 COOLER – Touch the
temperature.
6
WARMER – Touch the
temperature.
7
Press both the and
the temperature from Fahrenheit (°F) to Celsius (°C). Repeat
Step 7 to switch from °C back to °F.

To adjust fan speed

8
Touch the Fan Speed button to see the current setting. Touch
it again to change speed. F1 is the lowest setting (SLEEP
SETTING / LOW), F2 is MEDIUM, and F3 is HIGH.

To activate Smart Fan

9 There is a fourth option, SF, when selecting the fan speed. This is
the SMART FAN function. SMART FAN DOES NOT OPERATE
IN CONJUNCTION WITH THE FAN ONLY MODE.
Smart Fan will adjust the fan speed automatically to maintain
the desired comfort level. For example, if the outside doors
in your home are opened for an extended period of time, or
more people enter a room, Smart Fan may adjust to a higher
fan speed to compensate for the increased heat load. This
keeps you from having to adjust the fan speed on your own.
To set the hour clock
10
Touch the Set Hour button to see the current setting. The
number that is displayed is the approximate time (hour only).
Use the and buttons to change the settings. BE SURE
TO SET A.M. AND P.M. ACCORDINGLY. (P.M. is indicated by
a red light in the upper left corner of the display).
button to lower the room air
button to raise the room air
buttons at the same time to switch
920-007-12

To set the timer

NOTE: Set the HOUR CLOCK (Set Hour) before attempting to set
®
timer functions.
You can set the Start Time and Stop Time a minimum of one hour
apart, and a maximum of 23 hours apart.
11
After setting the time, press the Set Hour button once (Start
light on). Use the
unit will START.
12
After selecting the Start Time, press the Set Hour button once.
(Stop Light on). Use the
that the unit will STOP. After selecting the stopping time, press
the Set Hour button once.
13
Press the Timer On/Off button (light turns on) to activate the
timer function. To deactivate this function, press the Timer
On/Off button once again (light turns off). Once the on and off
times have been selected, they will remain in memory and cycle
daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the HOUR
must be reset or the Timer On/Off will not function when desired.

Automatic component protection

Your unit is equipped with Automatic Component Protection.
To protect the compressor of the unit, there is a three minute delay
if you turn the unit off or if power is interrupted. The fan will not be
affected. Also, if you switch from Cool mode to Fan Only mode, and
switch back to Cool mode, there is a three-minute delay before the
compressor comes back on.
and buttons to select the time that the
and buttons to select the time
5