Trouble Shooting - Grizzly Tools ERM 1743-20 Traduction De La Notice D'utilisation Originale

Trouble Shooting

Problem
Equipment does
not start
Motor stops
Result unsatis-
factory or motor
labours
Blade ( 19) fails
I
to turn
Strange noises,
rattling or vibra-
tions
Level indicator
( 17) does not
E
work
Possible Cause
Power is off
Defective start lever
( A 15)
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 19) blunt
I
Blade ( 19) area blocked
I
Blade ( 19) assembled incor-
I
rectly
19) blocked by grass Remove the grass
Blade (
I
Blade screw ( 18) loose
I
I
Blade screw ( 18) loose
Blade ( 19) damaged
I
Contamination
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Remove the foreign object
Set a higher cut height
Have the blade (
I
or replace it
Clean the equipment
Install the blade (
Tighten the blade screw (
Tighten the blade screw (
Replace the blade (
Cleaning with a soft brush. The
level indicator must close by itself,
if it was opened.
GB
19) sharpened
I 19) correctly
18)
I
I
18)
19)
I
33