General Cleaning And Maintenance Work; Changing The Blade; Storage; Waste Disposal And Environmental Protection - Grizzly Tools ERM 1743-20 Traduction De La Notice D'utilisation Originale

General Cleaning and
Maintenance Work
Do not hose down the lawnmow-
er with water.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that
all nuts, bolts and screws are sitting
firmly.
• Check the covers and protective devices
for damage and check that they are sit-
ting correctly. Replace them if necessary.

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade
is damaged or showing signs of imbal-
ance, it must be replaced (see chapter on
"Spare Parts").
1. Switch off the equipment, dis-
connect the plug and wait until
the blade stops.
2. Turn the equipment over.
3. Use sturdy gloves and hold the
blade firmly (19). Turn the blade
screw (18) anticlockwise off of
the motor spindle (20) using a
screwdriver (AF 13 mm).
4. Install the new blade in the
reverse order. Ensure that the
blade is positioned correctly and
the screw tightened firmly.

Storage

• Keep the equipment dry and out of
reach of children. Loosen the wing
nuts and fold down the handle bar so
the equipment takes up less space.
See the diagramm
cable is not caught.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
The apparatus can not be dis-
posed of with regular household or
bulk waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implement-
ed. Ask our Service-Center for details.
• You can find out more about waste
collection sites and times through your
local administration office or waste dis-
posal company.
GB
. Ensure that the
31