Remote Controller Specifications - Danby DAC150BBCWDB Guide D'utilisation Et D'entretien

OPERATING INSTRUCTIONS

REMOTE CONTROLLER SPECIFICATIONS

Model
Rated Voltage
Battery Type
Battery Quantity
Lowest Voltage of CPU Emitting Signal
Signal Receiving Range
Environment
ON/OFF BUTTON
Operation starts when this button
is pressed and stops when the
button is pressed again. NOTE:
The unit will automatically launch
the Energy Saver function when
it is in Cool, Dry, and Auto modes
(Only Auto-Cool and Auto-Fan
modes.)
TEMP UP BUTTON
Push this button to increase the
temperature setting in 1°C (1°F)
increments to 30°C (86°F) .
FAN BUTTON
Used to select the fan speed in
four steps:
LOW MED HIGH
ENERGY SAVER BUTTON
Press this button to activate the
energy saving mode. Press it
again to stop the function. This
function is available in COOL,
DRY, and AUTO modes (only
Auto-cool and Auto-fan modes).
AUTO
Model / Modèle :
R15B
3.0V
Button cell: CR2025
1pcs
2.0V
8m
-8°C to 60°C (18°F to 140°F)
R15B
7
MODE BUTTON
Each time you press this button,
a mode is selected in a sequence
that consists of AUTO, COOL,
DRY, FAN, and back to AUTO.
TEMP DOWN BUTTON
Push this button to decrease the
indoor temperature setting in 1°C
(1°F) increments to 17°C (62°F).
TIMER BUTTON
Push this button to activate the
"Auto Start" or "Auto Stop" pro-
gram from 0-24 hours (0.5/1 hour
increments).
SLEEP BUTTON
Press this button to activate the
SLEEP mode. This function is
available in COOL, and AUTO
modes only, and maintains the
most comfortable temperature for
you.