Remote Control Specifications - Danby DPA085B1GB Instructions

CAUTION
Do not mix old and new batteries or batteries of dif ferent types.
Do not leave the batteries in the remote controller if it is not going
to be used for more than 2 months.
Dispose of the old batteries in special containers such as those
found in the sales outlets.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
1) Reorient or relocate the receiving antenna
2) Increase the separation between the equipment and receiver
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4) Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not approved by the party responsible for FCC compliance could void the user's
authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired
operation.
CAN ICES-3 (B) / NMB-3 (B)

Remote Control Specifications

Model
Rated Voltage
Signal Receiving Range
Environment
NOTE:
Temperature setting display: press and hold the UP and DOWN buttons at the same time
for 3 seconds to alternate the temperature display between °C and °F.
Performance Feature
1. Operating Mode: AUTO, COO L, DR Y, and FAN.
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range: 17°C ~30°C (62°F~86°F).
4. Full Function of LCD (Liquid Crystal Display)
:
NOTE
All the illustrations in this manual are for explanatory purposes only.
Your air conditioner may be
RG51I45/BGCE
3.0V( 2-AAA )
8m
-5°C to 60°C (-41°F to 140°F)
3