Remote Control - Danby Silhouette DDR600R Manuel D'utilisation

Remote Control Features
The hand held remote unit allows you to control all
operational aspects of your dehumidifer from the
convenience of your favorite armchair. Here are
some things you should know about operating the
unit with the hand held remote.
Control Buttons
I/O: Power switch (On/Off).
MODE: Selects the required operating mode
(Dehumidifier Mode /Fan Mode).
Selects the fan speed settings (HIGH FAN / LOW FAN).
:
Each time the button is pressed will alternate
between HI FAN and LOW FAN speed.
Used to adjust (decrease) relative humidity
settings. Each time the button is pressed the
SET RH% value will decrease by 5%
(adjustable values between 80% ~ 35%) This
button can also be used to decrease the auto
timed (delay start / delayed stop) programs.
0.5 hr increments (from 0.5 hrs. ~ 10hrs.)
1.0 hr increments (from 10hrs. ~ 24hrs.)
Used to adjust (increase) relative humidity
settings. Each time the button is pressed the
SET RH% value will increase by 5%
(adjustable values between 35% ~ 80%) This
button can also be used to increase the auto
timed (delay start / delayed stop) programs.
0.5 hr increments (from 0.5 hrs. ~ 10hrs.)
1.0 hr increments (from 10hrs. ~ 24hrs.)
: Used to initiate a delayed start "on" time
and/or delayed stop "off" time.
F / C: Used to switch temperature readings (LED
readout display) from Celsius to Farenheight.
Each time button is pressed will alternate
between both temperature scales.
All manuals and user guides at all-guides.com
To operate the hand held remote control will require
two "AAA"(1.5 volt) Alkaline batteries (included ).
Batteries should be replaced when:
a) No signal (beep) is heard from the main unit
b) The main unit does not respond to the any of the
Battery replacement:
1. Open the rear cover on the backside of the
2. Replace the (2) batteries "AAA" (1.5 volts)
3. Re-install lower cover.
4. If the remote control will not be used for extended
The remote operates within a range of 7 meters
(23 ft.) from the receiver located inside the main unit.
Any obstruction between the receiver and remote
may cause signal interference, limiting the ability to
program the main unit.
8
when pressing the buttons on the remote control
while attempting to program the main unit.
commands issued by the remote control unit.
remote control unit in the direction of the arrow.
Continue pulling (gently) until the cover separates
completely from the unit.
following the same orientation (polarity) as
depicted inside the battery chamber.(+/-)
periods of time (vacations etc.), batteries should
be removed.