Features; Remote Control Specifications - Danby DPA140HEAUBDB Guide D'utilisation Et D'entretien

Features

ELECTRONIC CONTROL INSTRUCTIONS
Before you begin, thoroughly familiarize yourself with the control panel and remote control and all its functions. Select the
functions you desire based on the associated symbol.
The unit can be controlled by the control panel alone or with the remote control.
Operating Instructions

REMOTE CONTROL SPECIFICATIONS

Model
Rated Voltage
Signal Receiving Range
Environment
1. Operating Mode: COOL, DRY, HEAT and FAN.
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range COOL: 18°C~32°C (64°F~90°F).
4. Indoor Setting Temperature Range HEAT: 13°C~27°C (55°F~81°F)
POWER button
1
Turns power on/off.
2 FAN button
Controls the fan speed. Press to toggle between three fan speeds,
Maximum, Medium and Low
UP and DOWN buttons
4 3
Used to adjust (increase / decrease) temperature settings (1°C/1°F increments)
or the TIMER setting in a range of 1~24hrs.
The control is capable of displaying temperature in degrees Fahrenheit or
degrees Celsius. *Converting from °C to °F can be done using the remote control
by pressing the °C/°F button.
MODE select button
4
Selects the appropriate operating mode. Each time you press
the button, a mode is selected in a sequence that goes from
COOL, DRY, HEAT and FAN. The mode indicator light illuminates
depending on the mode settings.
LED DISPLAY
Shows the set temperature in °C or °F (to toggle between °C and °F
press the °C/°F button on the remote control).
Error codes:
Lt - Low Temperature. The unit will defrost. The appliance will
start again once defrosting is complete.
PF - Probe failure, call for service.
Ft- Tank is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
Danby.00-UYKQ-46e (White) / Danby.01-UYKQ-46e(B) (Black)
3V
7m
-5°C to 60°C (-41°F to 140°F)
5