Handling The Remote Control - Danby DPA100E1BDB Mode D'emploi

Handling the Remote Control

•
The air conditioner will not respond if curtains, doors or other materials block the signal from the
remote control to the unit.
•
Prevent any liquid from contact with the remote control. Do not expose the remote control to direct
sunlight or heat.
•
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may
not function properly. Use curtains to prevent the sunlight from falling on the receiver.
•
If other electrical appliances react to the remote control, either move these appliances to another
location or consult your local dealer.
Replacing the Batteries
Location of the Remote Control
• Use the remote control within a distance of 7 m (23 ft.) from
the appliance, pointing it towards the receiver. Reception is
confi rmed by a beep.
CAUTION
2
To replace the remote battery:
1. Use a screwdriver to remove the
screw that secures the battery
cover.
2. Push the latch to the right side
and pull the battery cover out.
3. Replace the battery and slide
the battery cover back into the
remote.
4. Replace the screw that secures
the battery cover.