Setting The System Via The Base Station; Arming The System; Disarming The System; Home Mode - Medion P89400 Mode D'emploi

Setting the system via the base station

Arming the system

− Press the arm button "
beep: the system has been armed.
NOTICE!
If the entry/exit delay function has been activated, only the Delay Zone is
armed after the specified time delay (see under "Entry/Exit Delay" on page
95).

Disarming the system

− Enter the user code (default user code: 1234) and press the disarm but-
ton " " on the base station.
The base station emits a beep: the system has been disarmed.

Home mode

− Press the home button "
a beep: the system has been armed and is operating in home mode.
All sensors allocated to the Normal Zone are armed. All sensors allocated to
the Home Zone are disarmed.
NOTICE!
You can find further information on setting up the zones under "Setting up
the accessories in zones" on page 100.

Emergency mode

− Hold down the "#SOS" button for 3 seconds.
The alarm is immediately triggered and the siren sounds. At the same time,
the control panel rings the saved phone numbers.
" on the base station. The base station emits a
" on the base station. The base station emits
DE
EN
FR
93 of 168