Direct Registering Of Accessories To The Wireless Siren - Medion P89400 Mode D'emploi

Direct registering of accessories to the wireless siren

Irrespective of whether the system is armed or disarmed, press the connec-
tion button to switch to connection mode. The LED display lights up: you will
now be in connection mode for 20 seconds.
In order to directly register accessories to the wireless siren...
• ...now press the connection button on the rear of the wireless motion
sensor within 20 seconds
• ...pull the sensor and magnet on the door/window contact apart and
thus trigger the sensor within 20 seconds
• ...press a button on the remote control within 20 seconds
You will briefly hear a beep: the accessory has been successfully registered
to the siren.
The siren supports up to 20 wireless accessories.
Testing a connection
You can test a connection in two different ways:
• Press the Arm button on the remote control. The LEDs on the alarm siren
light up for 4 seconds: the connection was successful.
• Trigger a sensor that has already been connected to the siren and the
siren will sound.
If you do not hear a beep, the connection has failed and you need to regis-
ter the accessory to the siren again.
Deleting accessories
If an accessory is faulty, it is recommended that you delete all accessories
from the siren, especially in the case of a faulty remote control.
Irrespective of whether the system is armed or disarmed, press and hold
down the connection button until you hear three beeps (about 7 seconds
long).
All accessories or control panels connected to the siren will be deleted. In or-
der to use the siren again, the wireless accessories or the base station need
to be reregistered to the siren.
DE
EN
FR
83 of 168