Wireless Motion Sensor - Medion P89400 Mode D'emploi

Disarming the system
− Press the disarm button "
lights up (two beeps are emitted by the base station). The system is
disarmed.
Home mode
− Press the home mode button "
The system LED on the base station lights up. All sensors in regular zones are
armed, with the exception of the sensors in the home mode zone. The sen-
sors in the home mode zone are disarmed so that the user can move about
in the home.
Emergency mode
Irrespective of the status of the system, the alarm will be triggered as soon
as the " " button on the remote control is pressed.
At the same time, the base station will send an SMS notification ("
SOS
", whereby 01 is the number of the remote control) and call the saved
phone numbers.

Wireless motion sensor

The wireless motion sensor is used to monitor rooms or spaces and the
alarm is triggered as soon as movement is detected.
Activating/changing the battery
Two 1.5V batteries, type AA/LR6, are already inserted in the motion sensor on
delivery.
If these batteries are flat, replace them with new batteries of the same type.
1. Remove the cross-headed screw on the edge of the housing.
2. Separate both housing shells from one another.
3. Remove the empty batteries and insert the new batteries
in accordance with the polarities shown in the battery
compartment.
4. Reattach the housing shells and fix them in place again
with the cross-headed screw.
88 of 168
" to disarm the alarm system. The display
" on the remote control.
RC-01