Wipe Protection; Automatic Time Limit; Basic Settings - NEFF T1.D10 Serie Mode D'emploi

Wipe protection

If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a wipe protection
function. Touch the symbol. A signal sounds. The control
"

Automatic time limit

If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
hotplate indicator.

Basic settings

Your appliance has various basic settings. You can adapt these
settings to your needs.
Indicator Function
Automatic childproof lock
™‚
Switched off.*
‹
Switched on.
‚
™ƒ Audible signal
Confirmation signal and operation error signal switched off.
‹
Only operation error signal switched on.
‚
Confirmation signal and operation error signal switched on.*
ƒ
Automatic timer
™†
‹ Switched off.*
- Cooking time, after which the hotplates switch off
‚ ŠŠ
Duration of the timer end signal
™‡
10 seconds.
‚
30 seconds
ƒ n
1 minute.*
„
Activation of the filament circuits
™ˆ
Switched off.*
‹
‚ Switched on.
Last setting before the hotplate was switched off.
ƒ
Reset to basic setting
™‹
Switched off.
‹
‚ Switched on.
*Basic setting
26
and flash alternately in the
" ‰
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the wipe protection
function. You can switch off the hob at any time.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).