Keep Warm Function; Wipe Protection; Automatic Time Limit; Basic Settings - NEFF T8 T40 Série Mode D'emploi

Keep warm function

The keep warm function is suitable for melting chocolate or
butter and for warming food and cookware.
Switching on the keep warm function:
Select the hotplate using the twist knob.
1.
In the next 5 seconds, touch the L symbol.
2.

Wipe protection

If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a wipe protection
function. Touch the symbol. A signal sounds. The control
"

Automatic time limit

If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
hotplate indicator.

Basic settings

Your appliance has various basic settings. You can adapt these
settings to your needs.
Indicator Function
™‚ Automatic childproof lock
‹ Switched off.*
Switched on.
‚
Audible signal
™ƒ
Confirmation signal and fault notification switched off.
‹
‚ Only fault notification switched on.
Confirmation signal and fault notification switched on.*
ƒ
Automatic timer
™†
Switched off.*
‹
‚ - ŠŠ Cooking time, after which the hotplates switch off
Duration of the timer end signal
™‡
‚ 10 seconds.
30 seconds
ƒ n
1 minute.*
„
Activation of the filament circuits
™ˆ
‹ Switched off.*
Switched on.
‚
ƒ Last setting before the hotplate was switched off.
*Basic setting
and flash alternately in the
" ‰
– appears in the heat setting display. The keep warm function
is switched on.
Switching off the keep warm function:
Select the hotplate and touch the L symbol.
heat setting display.
After approximately 5 seconds, the hotplate is switched off, and
the residual heat indicator appears.
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the wipe protection
function. You can switch off the hob at any time.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
‹ appears in the
37