Removal Of Plastic Lock Plug And Installation Of Lock Cylinder - Steelcase TS Storage Directives D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION: Failure to follow the installation
instructions will cause inability to install lock.
Removal of Plastic Lock Plug and
Installation of Lock Cylinder
1.
Pull open plastic plug cover.
2.
While pressing the plug retainer tab to the right,
insert a coin or the head of a key into the slot and
o
turn 90
clockwise. This will unlock the case. You will
hear the lock mechanism open.
CAUTION: Make sure you unlock the
case BEFORE proceeding to step 3.
3.
Push plug retainer tab down and remove plastic
plug from parent unit.
4.
Position lock cylinder tab at 45
Insert lock cylinder at a tilted angle so the tab will
collapse.
CAUTION: Make sure the tab is
o
located at 45
or 2:00 before
inserting lock cylinder.
5.
Push lock cylinder into the hole until it stops and
turn the lock plug assembly clockwise 45
3:00 position) and remove the key.
o
or 2:00 position.
o
(or the
1
PLUG RETAINER TAB
2
TURN 90 o
C L
45
4
TAB
PLASTIC PLUG
COVER
3
COIN OR
HEAD OF KEY
PLUG RETAINER TAB
o
or 2:00
5
PLASTIC PLUG
o
45
3:00
Page 17 of 57
P/N 939504734
Doc # 70305 Rev K

Publicité

Table des Matières
loading

Table des Matières