Installation And Assembly; Safety Instructions; Checking The Delivery Contents; Disposing Of The Packaging Material - Steelcase Bivi Manuel D'utilisation

Installation and assembly

Installation and assembly

Safety instructions

WARNING
Danger of injury and damage!
When lifting on the desktop or attached components, the fastening screws
may tear.


Checking the delivery contents

After unpacking, the product must be checked immediately for transport damage and for completeness. Any
damage must be reported to the manufacturer as soon as possible.

Disposing of the packaging material

The packaging includes the following:
• Outer packaging made of cardboard.
• Polyethylene (PE) foil.
Bubble wrap made of polyethylene (PE).
•
Edge protectors made of cardboard or polyethylene foam (PE)
•
• Corner protectors made of polyethylene (PE).
• Particle board
Polypropylene (PP) tapes
•
These materials are recyclable. When the product is assembled by Steelcase or an authorised installer, the
packaging is disposed of by the manufacturer. If you install yourself, please ensure sorted separation and
return to the recycling cycle.

Installing the office furniture system Bivi

Installation and use of the product requires detailed planning. For this purpose, Steelcase offers its own
planning department.
The partially assembled components of the office furniture system Bivi are usually delivered by specialist
dealers or directly from the manufacturer.
Steelcase recommends assembly by a specialist dealer or an assembly company.
The installation location must meet the following requirements:
Sufficient carrying capacity of the floor.
•
• Horizontal storage surface.
• Temperature range +5 C to +35 C.
Bivi Manual -en- 2019
Transport or move the desk only by grabbing the base frame.
Page 18 of 53