Problems And Troubleshooting - Marmitek EASYTOUCH 35 Mode D'emploi

easytouch35_manual ok

17 Problems and troubleshooting

The remote doesn't work or looses codes entered
• Confirm with your original remote that the equipment works correctly
• Make sure that you have pressed the corresponding mode key of the equipment or
device that you want to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the next
code of that brand.
• To find the corresponding code for your equipment use the automatic search.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 4 AAA batteries (new). If the remote looses
codes within a few days/weeks the problem can be solved by using 4 new batteries
from the same brand.
• If the LED is lit permanently, in general it will be necessary to replace the batteries.
Important:
The ET35 must be used only in the way described in this instruction manual and may not
be used for a purpose not intended.
EASYTOUCH 35
6/17/03 10:30 AM Page 25
25