Marmitek EASYTOUCH 35 Mode D'emploi page 11

easytouch35_manual ok
under CBL, etc., then the Mode key must be "primed" for the new appliance. First
follow the "Programming using 3 Digit Code Table" procedure and then enter any
VCR code prior to carrying out the above search steps.
8 Programming using Manual Code Search
If you are unable to find your code either in the Code Tables or by using the Brand Search
Method, you can try all the available codes for the appliance using the Manual Code
Search.
EASYTOUCH 35
6/17/03 10:30 AM Page 11
1. Make sure your appliance is switched on. If not switch it
on manually.
2. Press and hold Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and display
shows Main Setup Screen.
Release Setup key.
3. Press and release the Touchscreen "CODE" Key.
4. Display will show the Mode Setup Screen. Press and release
desired Mode key (TV, VCR, SAT, etc.) on the rubber
keypad.
5. Display will show the Code
Setup Screen. Press and release
the Touchscreen "SEARCH"
Key.
11