Publicité
Les langues disponibles
Les langues disponibles
Warranty (cont.)
AND/OR SELLER DISCLAIM ANY LIABILITY FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states/provinces do not allow limitations on how long an implied warranty lasts, or the
exclusion or limitation of special, incidental or consequential damages, so these limitations and exclusions
may not apply to you. This warranty gives you specific legal rights. You may also have other rights which
vary from state/province to state/province.
This is Kohler Co.'s exclusive written warranty.
Troubleshooting
NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or qualified
electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within
the USA and Canada, or 001-800-456-4537 from within Mexico.
NOTE: The product model number is printed on a label on the pump/blower side of the bath.
NOTE: For service parts information, visit your product page at www.kohler.com/serviceparts.
Air System
Symptoms
Blower motor does not
1.
start or stop.
Kohler Co.
Probable Causes
A. No power to the blower motor.
B. Air actuator tubing is loose or
disconnected.
C. Air actuator tubing is pinched or
kinked.
D. Air system button assembly is
damaged.
E. Air system button assembly has
grease or debris in the bleed area.
F.
Air actuator tubing is damaged.
G. Blower motor does not work.
21
Recommended Action
A. Make sure nothing except the
pump and blower/heated surface
are plugged into their shared
duplex outlet. Set or reset the
GFCI or RCD. Check and repair
the wiring.
B. Check that the air actuator
tubing is connected to the air
switch actuator, and to the air
switch button. Reconnect if
needed.
C. Adjust the air actuator tubing to
clear the pinched or kinked area.
If the air actuator tubing is
pinched or kinked, and cannot be
adjusted, or if no noticeable
pinch or kink is apparent, use a
tack to poke a small hole in the
air actuator tubing. Test
operation.
D. Replace the air system button
assembly.
E. Disassemble the air system
button assembly, and wipe away
any excess grease or debris.
Reassemble the air system button
assembly, and test operation.
F.
Replace the air actuator tubing.
G. Replace the blower motor.
1267113-2-C
Publicité
