Kohler K-156 Guide D'installation page 12

Heated Surface Control
Air System
9. Test Operation
Test Run the Bath
NOTICE: When testing the heated surface functions, allow 5 to 10 minutes to begin feeling heat on the
end wall.
Operate the heated surface user keypad to test the temperature settings.
Fill the bath at least 2" (51 mm) above the top of the highest whirlpool jet.
Operate the bath for 5 minutes and check all piping connections for leaks. Check for leakage along
the front, sides, and back of the bath.
Turn on each of the bath features, and verify proper function.
For additional information on whirlpool, airbath, and heated surface operation, see the "Operating
Instructions" section.
Turn off the features, then completely drain the water from the bath.
1267113-2-C
Whirlpool System
12 Kohler Co.