Kohler K-156 Guide D'installation page 16

Press once for high flow.
Press a second time for medium flow.
Press a third time for low, "Back Only" flow.
Press a fourth time to turn off.
Operating the Air System
NOTE: This is a combination airbath and whirlpool bath, and includes a heated back surface. For
information on using the whirlpool features, refer to the "Operating the Whirlpool System" section. Refer
to the "Operating the Heated Surface" section to use the heated surface feature.
NOTE: If the unit does not function properly, please refer to the "Troubleshooting" section.
Before entering the bath, make sure the seal is free of dirt and debris.
Enter the bath, then close and latch the door.
Use your hand to test the water temperature before closing the drain and filling the bath.
Fill the bath at least 4" (102 mm) above the top of the airjets.
Press the three-speed air system button once to start the air system at high speed.
Press the air system button a second time to operate the air system at medium speed.
Press the air system button a third time to operate only the back airjets at low speed.
Press the air system button a fourth time to shut off the air system.
When you are done bathing, open the drain and remain seated while the water drains from the
bath.
When the water has drained from the bath, unlatch and open the door.
Carefully exit the bath.
NOTE: For questions or additional information, call 888-9-BOLD-4-U and speak with a KOHLER Bold
Independence Expert.
IMPORTANT! A built-in timer automatically stops the blower and motor after approximately 20 minutes
of operation.
IMPORTANT! This product contains an automatic water purge mode that turns the blower on for 1
minute approximately 30 minutes after the unit is turned off and drained.
1267113-2-C 16 Kohler Co.