Kohler K-156 Guide D'installation page 17

Heat/Temperature Indicator
Operating the Heated Surface
Keypad Operation
Power Icon - Turns the heater on and off.
Heat/Temperature Indicator - The [Flame] icon illuminates yellow, orange, or red depending on the
heat level. Yellow indicates low heat, orange indicates medium heat, and red indicates high heat.
Up Arrow - Increases the temperature.
Down Arrow - Decreases the temperature.
NOTICE: The heater will remain on until it is manually turned off by pressing the [Power] icon.
NOTE: After 60 minutes of inactivity, the heater will automatically reset to low heat if the temperature
was set to medium or high. The heater will remain on at low heat until it is manually adjusted or turned
off.
NOTE: The heater will turn on at the last selected temperature setting.
Error Codes
Heat indicator blinking red - The heater is not functioning.
Heat indicator blinking yellow - The temperature sensor is not functioning or is loose.
Refer to the "Troubleshooting" section to troubleshoot any problems.
Confirm Heated Surface Operation
NOTICE: When testing the heated surface functions, allow 5 to 10 minutes to begin feeling heat on the
end wall.
Press the [Power] icon on the user keypad.
Observe that the heat indicator turns yellow and the heater produces low heat.
Press the [Up] arrow. Verify that the heat indicator turns orange and the temperature increases.
Press the [Up] arrow a second time. Verify that the heat indicator turns red and the temperature
increases.
Press the [Down] arrow. Verify that the heat indicator turns orange and the temperature decreases.
Press the [Down] arrow a second time. Verify that the heat indicator turns yellow and the
temperature decreases.
Press the [Power] icon to turn the heater OFF.
Kohler Co.
Power On/Off
Increase Temperature
Decrease Temperature
17 1267113-2-C