How To Set The Unit; Control Panel; Main Functions - Nicols IP WASH 270 FC Manuel D'utilisation

IP 66
Dimension：687 x 208 x 305 mm
Weight：22.2 kg

3. How To Set The Unit

3.1 Control Panel

 Power Water proof connectors for power input.
DMX input Water proof connectors for DMX 512 operation, 3-pin XLR cable to input DMX signal.
Connect to lamp panel.
DMX output Water proof connectors for DMX 512 operation, 3-pin XLR cable to output DMX signal.
Display and Button:
Display: To show the menu and the selected functions.
Button:
MENU
DOWN
UP
ENTER

3.2. Main Functions

Open the cover and remove it then you can set the menu manually
To select any functions, press MENU button until the required one is shown on the display. Select the function by ENTER button and
the display will blink. Use DOWN and UP button to change the mode. Once the required mode has been selected, press ENTER
button to setup or it will automatically return to the main functions without any change after idling one minute. Back to the functions
without any change press MENU button.
Once you set to
board become locked. Press ENTER button to enable the menu, the display will show
until it shows password you have set before, then press ENTER to unlock. initial password is
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
, after running in show mode for 5 minutes without any change or restarting the unit, the key
13
, press UP and DOWN button
.