How To Control The Unit - Nicols ZAP LED DMX Manuel D'utilisation

button and the display will blink. Use DOWN and UP button to select the
(3channels), (9 channels) or
setup or automatically return to the main functions without any change after 10 seconds.
Back to the previous functions without any change press MENU button.
Master/Slave Mode
Press the MENU button up to when the
button, Use DOWN and UP button to select the
(Slave Mode master, normal, 2, 3, or 4). Press ENTER button to setup or
automatically return to the main functions without any change after 10 seconds. Back to the
previous functions without any change press MENU button.
Show Mode
Press the MENU button up to when the
UP button to select the
... ...
automatically return to the main functions without any change after 10 seconds. Back to the
previous functions without any change press MENU button.
Sound Mode
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(sound off) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To
go back to the functions without any change press the MENU button again.
Blackout Mode
Press the MENU button up to when the
UP button to select the "Yes" or "No" Blackout, Back to the previous functions without any
change press MENU button.
LED
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select the "ON" or "OFF"
(28 channels) mode, press ENTER button to
is shown on the display. Pressing ENTER
, ,
is shown on the display. Use DOWN and
or . Press ENTER button to setup or
is showing on the display. Pressing ENTER button
(sound on) or
is shown on the display. Use DOWN and
is shown on the display. Pressing ENTER
18-
mode. Once the mode has been selected, press ENTER button to setup or automatically
return to the main functions without any change after 10 seconds. Back to the functions
without any change press MENU button again.
Display Inverse
It is good for you to install the unit on the floor or under ceiling. Press the MENU button up to
when the
(display normal), It will automatically store after 10 seconds. Or press the ENTER
, or
button again return to the mode
press the MENU button.
Press the MENU button up to when the
button and the unit will run self-test by built-in program. To go back to the functions press the
MENU button again.
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button again.
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.

5. How To Control The Unit

Three ways to operation:
A. Master/Slave operation
B. Easy controller CA-8
C. Universal DMX controller
is blinking on the display. Use the ENTER button to change to the mode
(display inversion). To go back to the functions
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Self-Test
is blinking on the display. Pressing ENTER
Fixture Hours
is blinking on the display. Pressing ENTER
Software version
is blinking on the display. Pressing ENTER
19-