Technical Specification; How To Set The Unit - Nicols HOP'S Manuel D'utilisation

Do not open the unit within five minutes after switching off.
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the
unit is firmly fixed to avoid vibration and slipping while operating. Make sure that the
bracer can support the weight more than 10 times of the unit. And use safety chain which
can hold over 12 times weight of the unit when you fix the equipment.
The equipment must be fixed by professionals. And it must be fixed at a place where is
out of the touch of human and has no one pass by or sit down.

2. Technical Specification

• The unit is DMX 512 fixture. It features full DMX 512 control. It can be also linked together
in master/slave connection, as many as required and run by built-in program chase
sequences automatically or by sound activation through an internal microphone to create
an intelligent effect.
• It can be operated by DMX 512 control or can be used as an individual unit without a
controller.
• Features different preprogrammed chase patterns.
• Please use a cable when connecting units together.
• Accurate focusable optics system and ultra smooth stepping motors, Fan cooled.
• Pan: 540 deg. Tilt: 220 deg.
• Voltage: 100-240V~50/60Hz
• Light Source: 1×20W LED
• Dimension: 184.6 x 199.8 x 389 mm
• Weight: 4.6 kg
16-

3. How To Set The Unit

3.1 Control Panel
Display
To show the various menus and the selected functions
LED
DMX On
MASTER On
SLAVE On
SOUND Flashing
Button
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
Mains input
IEC socket and integrated fuse holder, connect to main power cable.
Only for remote control
By connect to the 1/4'' microphone jack to control the unit for Stand by, Function and Mode
function.
Sensitivity
To adjust the sound receiving sensitivity
DMX input/output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
3.2 Main Function
To select any of the given functions, press the MENU button up to when the required one is
showing on the display. Select the function by ENTER button and the display will blink. Use
DMX input present
Master Mode
Slave Mode
Sound activation
17-