Connecting To A Network - Sony IPELA NSR Serie Manuel D'installation

Caution
• Before installing, carefully read "Important
Information About Safety" (page 3). When using the
unit in combination with multiple NSR units or an
optional NSRE-S200, make sure that the power
supply is sufficient.
• For details on the current consumption and inrush
current for the NSR-1200/1100/1050H and NSRE-
S200, see "Reference Data for Installation" (page 10).

Connecting to a Network

Connect to the network as follows.
Remote client
Connect LAN connector to the same network as the
Windows PC being used as the remote client.
Network switch
LAN connecter 1
Network switch
Network cameras
Connect LAN connector 1 to
the same network as the
network cameras.
Connections to remote clients
When a remote client is necessary, you can use the
RealShot Manager Advanced client software supplied
with this unit.
• Use the version of RealShot Manager Advanced
supplied with this unit. For details on how to
download the installer for RealShot Manager
Advanced, see "Downloading Files Stored on the
NSR" (page 6). For details on installation and
connecting to the NSR, refer to the RealShot Manager
Advanced Installation Guide (PDF).
• RealShot Manager Advanced client software operates
on Windows computers. For details on recommended
system specifications, refer to the release notes
included in the install archive for RealShot Manager
Advanced client software.
RealShot
Manager
Advanced
Client software
Windows PC
LAN connecter 2
LAN connectors 3 and 4
(used for iSCSI storage)
• When using RealShot Manager Advanced as a remote
controller for the NSR, select [Client] during
installation of RealShot Manager Advanced.
• When connecting to the user area network, use LAN
connector 2.
• For details on NSR settings when using the RealShot
Manager Advanced client software, see
"Configurations for Using RealShot Manager
Advanced Client Software" (page 27).
LAN connectors 3 and 4 (used for iSCSI storage)
As LAN connectors 3 and 4 are channel bonded for
network redundancy, only one IP address can be
assigned for both connectors.
Caution
Do not use iSCSI storage in conjunction with an NSRE-
S200.
Notes
• The default IP addresses for this unit are as follows.
- LAN connector 1: 192.168.0.1
- LAN connector 2: 192.168.1.1
- LAN connector 3: 192.168.2.1
- LAN connector 4: 192.168.2.1
• If you want to change the default IP addresses, refer to
the User's Guide (PDF).
17
Step 2: Connections