Connecting The Keyboard, Mouse And System Controller; Connecting The Power Cord - Sony IPELA NSR Serie Manuel D'installation

Recommended connector use while operating
the unit
Monitor Connectors to use
HDMI
monitor
connector
1
One HDMI
a
monitor monitor
Analog
–
RGB
monitor
Two HDMI
a
monitor × 2
monitors
Analog
–
RGB
monitor × 2
HDMI
a
monitor and
Analog
RGB
monitor
–
Notes
• There are three monitor connectors labeled "1"
(analog RGB ×2; HDMI ×1) and two monitor
connectors labeled "2" (analog RGB ×1; HDMI ×1),
but only one of each (1 and 2) can be used at any one
time.
• Do not turn on the unit while monitors are connected
to analog RGB monitor connector 1 on both the front
and rear of the unit.
• When operating the unit with only one analog RGB
monitor, do not connect the monitor to analog RGB
monitor connector 1 on the front of the unit while the
unit is turned on.
• When connecting two analog RGB monitors, do not
use the HDMI monitor connectors.
• When using HDMI monitors, be sure to connect the
HDMI monitor and turn it on before turning on the
unit.
• When an HDMI monitor is connected to HDMI
monitor connector 2, the reboot and shutdown screens
are only displayed on monitor 2.
• Do not connect a monitor to HDMI monitor connector
1 when using analog RGB monitor connector 1 on the
front of the unit.
• When monitors are connected via a monitor switch,
images may not always display. We recommend
connecting monitors directly to the unit.
16
Step 2: Connections
HDMI Analog Analog
monitor RGB RGB
connector monitor monitor
2 connector connector
1 2
– – –
– a –
a
– –
– a a
– – a
a a –
Connecting the Keyboard, Mouse
and System Controller
Connect the devices to the USB connectors on the front
and rear of the unit.
Example) When connecting to the USB connectors on
the rear
Keyboard
System controller
Notes
• This unit supports RM-NS1000 system controller and
IP Desktop USB controllers from CH Products. Other
remote controllers are not supported. Do not connect
more than one remote controller.
• When using USB devices, be sure to read "Precautions
for using USB devices" (page 4) in the "Usage
Precautions" section beforehand.

Connecting the Power Cord

Connect the power cord to the power supply connector.
Attach the safety clip to prevent the power cord from
disconnecting.
Mouse