Connecting The Keyboard, Mouse And System Controller; Connecting To A Network; Connecting The Power Cord - Sony NSR-500 Série Manuel D'installation

Connecting the Keyboard,
Mouse and System
Controller
Connect the devices to the USB connectors
on the unit.
Example)
Keyboard
System controller
Notes
• This unit supports RM-NS1000 system
controller and IP Desktop USB
controllers from CH Products. Other
remote controllers are not supported. Do
not connect more than one remote
controller.
• When using USB devices, be sure to read
"Precautions for using USB devices"
(page 8) in the "Usage Precautions"
section beforehand.
Connecting the Power
Cord
Connect the power cord to the power supply
connector.
Attach the safety clip to prevent the power
cord from disconnecting.
Caution
Mouse
Before installing, carefully read "Important
Information About Safety" (page 7). When
using the unit in combination with multiple
NSR units, make sure that the power supply
is sufficient.

Connecting to a Network

Connect to the network as follows.
Remote client
Connect LAN connector to the same
network as the Windows PC being used as
the remote client.
Network hub
Network hub
Network cameras
Connect LAN connector 1 to the same
network as the network cameras.
Windows PC
RealShot Manager
Advanced
Client software
LAN connecter 2
LAN connecter 1
Step 2: Connections 21