Publicité
Les langues disponibles
Les langues disponibles
Second Section - FOR THE INSTALLER
During installation carry out a good machine levelling, which is a prerequisite for a correct
operation thereof.
The Manufacturer cannot assume any responsability for any damage to persons or
property deriving from the non-observance of the above specified norms.
For a correct installation see the drawing on page 18.
The dishwasher shall be installad in accordance
with local codes, or in the
codes,
installed
in accordance with the
applicable requirements in
Electrical Code, NFPA 70,
Code (CEC), C22.1, and Standards
Ventilation Control and Fire Protection of
Commercial Cooking Oper 96.
ELECTRICAL CONNECTION
Before connecting the machine, make sure
the voltage outlet of the mains is the same as
the voltage specified on the data plate of the
machine.
A flexible cord used in a power-supply shall be
Type S, SE, SO, SOO, ST, STO or STOO. The
length of the cord -
the attachment plug to the point of entry into the
dishwasher – shall not be less than 59,00 in.
Ground Markings - States "G",
equivalent markings such as the ground symbol.
Located near equipment
inside the field wiring compartment.
Supply Connection Markings - Each unit will be
marked as follows, "Minimum Supply Conductor
GROUNDING - All products shall
for grounding through the supply cord of a cord
connected product or through a grounding
terminal of a field wired product.
shall be separated from the
All exposed dead-metal parts of the enclosure
and all dead-metal parts within the enclosure
likely to be contacted by the operator or
serviceman during normal use or servicing, shall
be conductively bonded to
connection.
The conductors used for bonding individual
dead-metal shall be insulated and equal to
greater than the largest AWG size of the
absence of local
the
National
Canadian Electrical
measured from the face of
"GND", "GR" or
grounding terminal
have means
The ground
neutral conductor.
the
ground
for
conductor of the component mounted to the
dead-metal or routed along the
accordance with the National Electric Code,
ANSI/NFPA 70.
The ground shall be connected to the frame or
enclosure by a positive means penetrating any
nonconductive coatings and located so that it is
unlikely to be removed during normal servicing.
Ground wires shall be identified by green with or
without one or more yellow striped, and no other
lead
Ground terminals shall be identified by the use
of one of the following:
1) Identified by
Publication 417, Symbol No. 5019) on or
adjacent to the connector.
2) Identified by "G", "GR", "GND", "Ground" or
equivalent.
3)
Use of a hexagonal or slotted (or both)
green head wire-binding
4)
Use of a threaded stud with a
hexagonal nut.
5) Use of a green pressure terminal connector.
THE MACHINE SHALL BE CONNECTED
WITH AN EFFECTIVE GROUND CLAMP.
The manufacturer declines any responsibility
for any damages caused by lack of an
or
effective
ground installation.
shall be so identified.
the ground symbol (IEC
ENGLISH
dead-metal in
screw.
green
Publicité
