Blue Auxiliary Button Enabling; Cloning Functions; Available Function Presentation From The Keypad - Nidec Leroy-Somer Field Keypad RTC Manuel D'installation

3.3 - Blue auxiliary button enabling

In keypad mode (Pr 00.005 / 11.034 = Keypad or Keypad Ref), to validate the keypad blue
button (disabled by default), select parameter 06.013 and set according to application needs:
• Pr 06.013 = Forward/Reverse.
Run forward command is given using the green button and when the blue button
is pressed, keypad reference is toggled between Run forward and Run reverse.
• Pr 06.013 = Run Reverse.
Run forward command is given using the green button. Run Reverse command
is given using the blue button.

4 - CLONING FUNCTIONS

4.1 - Available function presentation from the keypad

Field Keypad RTC allows the user to store up to 5 drive parameter sets (.parfile) and 1
CodeSys application program (.app).
The parameter set or the program is uploaded from the drive to the internal Flash memory of
Field Keypad RTC. Then, it can be downloaded in other drives if necessary.
CAUTION
• The parameter sets of the Commander ID300/302 optional modules (fieldbus and I/O)
are not stored in the keypad flash memory.
• Before downloading a parameter set to a drive, the keypad checks that the
destination drive has the same type/rating as the source drive (ID300 or ID302,
power, voltage and motor polarity). If this is not the case, the keypad will display the
error message «Err Product ID». When downloading a Codesys program, no check
is performed.
• The flash memory of the keypad has a limit of approximately 100 backups.
• If the battery is changed, the program and parameter files remain stored in the flash
memory of the keypad.
• The cloning function of the Field Keypad RTC is not valid for other Nidec Leroy-Somer
drives. Only use it for the Commander ID300/302 or ID300K/302K range.
The cloning functions are available from parameter Pr mm.000 (parameter 000 of any menu)
and are highlighted in grey hereafter. Other functions are available from this parameter and
they are listed hereafter too.
20
Field RTC Keypad
Installation and connections
5690 en - 2020.03 / c