Nidec Leroy-Somer Field Keypad RTC Manuel D'installation page 17

Step 1: unscrew the protective plug of the side flange RJ45 connector by one quarter-turn.
Step 2: connect the keypad cable to the connector. Power up the drive if this has not been done
already (can be connected when the drive is powered on). Make the required settings for the
application.
Step 3: once settings or diagnostics are finalized, unplug the RJ45 cable from the side flange,
and screw the protective plug again.
2.2 - Drive internal connection
This connection procedure can be used for first commissioning or one-off setting by an autho-
rized person. In the other cases, the side flange option with RJ45 connector must be used as
described in section 2.1.
• Install or uninstall Field Keypad RTC option at least 10 minutes after the
Commander ID300/302 power down.
• When the cover is open, the Commander ID300/302 degree of protection is
IP10. Any work should only be carried out by experienced and qualified per-
sonnel. Once the drive powered on, to do the settings with the Field Keypad RTC, an
electrical authorization is necessary. If this is not the case, always use the side flange
with RJ45 as described in section 2.1.
Installation and connections
5690 en - 2020.03 / c
Field RTC Keypad
1
RJ45
2
17