Operation With Preheated Water; Service Information - Stiebel Eltron DCE-X 6/8 Premium Utilisation Et Installation

Masquer les pouces Voir aussi pour DCE-X 6/8 Premium:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
iNSTallaTiON

Service information

f Remove the function module from the appliance back panel
by pulling it slightly forwards and lifting it off.
f Push/break out the required apertures for the water connec-
tions in the back panel from behind (for positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
f Fit the function module on the appliance back panel in re-
verse order until it clicks into place.
f Secure the function module with the screw.
Installing the appliance
1
1 Grommets
2 Flat gasket
3 Strainer with sealed edge
f Mark out the 2 drilling positions in the upper section of the
appliance back panel with reference to the appliance back
panel.
f Fit the grommets in the appliance back panel from the front.
f Drill the holes and secure the appliance using suitable fixing
materials (screws and rawl plugs are not part of the standard
delivery): Countersunk screw, Ø 4.5 mm, max. diameter of
screw-head 9 mm.
Note
f Install the appliance flush to the wall. If necessary,
additionally secure the appliance at the 2 lower
attachment points. To do this, push/break out the
lower slots (175 mm apart) in the appliance back
panel (for positions, see chapter "Specification / Di-
mensions and connections").
f Remove the transport protection plugs from the water con-
nection pipes.
f Secure the DHW connection pipe with a flat gasket and the
cold water inlet line with the sealed-edge strainer (from the
accessories) to the twin nipples.

13.6 Operation with preheated water

You can limit the maximum inlet temperature by installing a cen-
tral thermostatic valve.
www.stiebel-eltron.com
2
3
14. Service information
Connection overview / component overview
1
2
3
1 Motorised valve
2 Flow meter
3 High limit safety cut-out, automatic reset
4 NTC sensor
5 Pin strips for connected load and anti-scalding protection
6 Programming unit plug-in position
7 Diagnostic traffic lights
4
5
6
7
DCE-X Premium |
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dce-x 10/12 premium

Table des Matières