Publicité
Les langues disponibles
Les langues disponibles
Smart Charging Mode
There are following stages:
•
Sof start Charging Mode (C.C. Mode)
-
Blue
Charging LED is flashing.
-
Gently ramps up the battery voltage to 11V
•
Bulk Charging Mode (C.C. Mode)
-
Blue
Charging LED is ON.
-
The battery can be charged about 80%.
-
The charger delivers an almost constant current 1500mA until the battery voltage reaches the set value.
•
Absorption Mode (C.V Mode)
-
Blue
Charging LED is ON.
-
The battery can charge up to almost 100%.
-
The charging current tapers and the charging voltage are kept constant at the set value.
•
Analysis Mode ( Battery retention test Mode)
-
The charging is interrupted for a short period for battery voltage measured
-
If the battery voltage falls too quickly, the battery is probably faulty.
-
The
yellow
Charging LED is ON (if above situation occurred)
•
Float Mode (Safe voltage level of 13.6V)
-
Full
green
LED is ON.
-
The Float Mode allows the charger to effectively be left connected to your batteries; it works at a safe level of 13.6V, and ready
for use.
•
Maintenance mode (Special pulse for long term maintenance)
-
green
Full
LED is ON.
-
The program engages a special charging waveform and monitors the battery voltage variety, if the battery voltage sinks, the
special pulses will keep the battery in optimal state, if the battery voltage drops even lower, the battery charger will switch into
Bulk charging stage. The maintenance mode allows the charger can be connected to the battery over the course of a season;
if possible; check the electrolyte liquid level in the battery.
LED STATUS INIDICATOR TABLE
LED
Status
Power / Fault LED – White /
White
ON
White
Flash
Red
ON
Charge / Reconditioning LED –
Blue
Flash
Blue
ON
Yellow
ON
Full LED -
Green
Green
ON
CHARGING CURVE
•
Initial qualification: test automatically battery condition and determine if chargers engages rejuvenation or charging cycle.
•
Rejuvenation: rejuvenates sulphated batteries with a high frequency pulse.
•
Soft start: increases battery life by gently starting to charge the battery.
•
Bulk charge: reduces charging time by delivering maximum charge to set voltage.
•
Absorption: ensures a full charge to the battery without overcharging.
•
Battery test: tests the battery to ensure fully charged.
•
Float: float charge maintains the battery at 100% charge. 21 days restart.
•
Long term maintenance: if the battery voltage sinks, the special pulses will keep the battery in optimal states.
| www.bs-battery.com
Description
Red
AC power is connected
ECO mode and no battery presented
Short –circuit or Reverse polarity
Blue
/
Yellow
Recondition / Soft start
Bulk charge (C.C) mode / Absorption charge (C.V) mode
Battery is flat (less than 2V)
The charger is at Float mode (Full)
7
Publicité
