TFA 60.2523 Mode D'emploi page 11

TFA_No. 60.2523_Anleitung
Radio-controlled alarm clock
Important information on product safety!
• Do not place your product near extreme temperatures, vibra-
tions or shocks.
• Protect it from moisture.
5. Elements
A: Display:
A 1: Time with seconds / weekday
A 2: DCF signal
A 3: Date / alarm time
A 4: Alarm symbol
B: Buttons:
B 1: ▲ button / Snooze/Light button
B 2: ▼ button / Snooze/Light button
C: Housing:
C 1: Alarm on/off button
C 2: IR motion sensor
20
18.06.2013 9:33 Uhr Seite 11
Radio-controlled alarm clock
C 3: Sliding switch for calendar (Date set),
for time (Time set),
for alarm time (Alarm set),
LOCK (black bar)
C 4: Battery compartment
6. Getting started
• Slide the battery compartment lid downwards and remove the
battery insulation strip. All LCD segments will be displayed for
about a few seconds. Close the battery compartment again.
• The clock will now scan the DCF frequency signal and the DCF
symbol will be flashing on the LCD. When the time code is
received successfully after 3-5 minutes, the radio-controlled
time is displayed and the date and the DCF symbol is displayed
steadily in the LCD.
• If the reception fails, scanning stops and will be repeated
between 2:15, 3:15, 4:15 and at 5:15 a.m.
• If the clock cannot detect the DCF-signal (for example due to
disturbances, transmitting distance, etc.), the time can be set
manually. The clock will then work as a normal quartz clock.
(see: Manual setting of the clock and calendar).
21