Hilti DX 76 Mode D'emploi page 32

8.3.3 Criteria for replacement of wear parts
Piston and piston stopper wear criteria
Status
New condition
Worn
Always replace the pis-
ton and piston stopper
together.
Nosepiece wear criteria
Status
New condition
Worn
Have it replaced by
Hilti Service
8.3.4 Cleaning and oiling fastening tool
Use only Hilti spray. The use of other lubricants can cause malfunctions or damage the fastening tool.
Apply the Hilti spray only as a thin film. It is not permissible for beads to form. For example, after
applying the Hilti spray, rub the oiled surface down lightly with the cloth supplied with the spray.
Make sure that no oil makes its way into the cartridge chamber!
1. Unload the fastening tool (cartridges and fasteners) and dismantle the fastening tool. → page 25
2. Use the brushes supplied to clean the piston and piston guide (outside (1) and inside (2)).
26 English
Illustration showing example
Illustration showing example
10
Annotation
Signs of chipping at the tip / face
of the piston.
The piston has made a deep im-
pression (3 mm or more) in the
piston stopper.
Annotation
Obvious signs of chipping.
282471
*282471*