Table des Matières
Publicité
Installation
EN
Before you start
All installation must be carried out by a competent person or qualifi ed electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct connection
•
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a
minimum opening of 3 mm between the contacts.
•
The installer must ensure that the correct electrical connection has been made and that it complies
with the wiring diagram.
•
The cable must not be bent or compressed.
•
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be
replaced by a special cord or assembly available from the manufacturer or its service agent.
WARNING: This is a Class I appliance and MUST be earthed.
•
This appliance should be connected directly to the mains power supply with a 3 Amp fuse protecting its
circuit.
•
This appliance is supplied with a 3 core mains cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
To avoid the risks that are always present when you use an electrical appliance it is important that this
appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.
After unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but
contact Customer Services - see end of Care & Maintenance section for details.
Once the electrical connection point and routing of the mains cable is established ensure that any excess
cable is secured in such a way to prevent it falling into the motor housing and damaging the appliance.
208862_s1_s1-5059340127538-C&L-A5-IM-Easy-V02.indd 16
208862_s1_s1-5059340127538-C&L-A5-IM-Easy-V02.indd 16
16
19/10/2020 6:56 PM
19/10/2020 6:56 PM
Publicité
Table des Matières
