Publicité
Les langues disponibles
Les langues disponibles
Permanent signal of output 2,
will become passive at count
value
mode and at count value
subtracting mode
Timed signal of output 2 will
become passive at count value
at count value
ing mode
Timed signal of output 2 is ac-
tivated at count value
2 in adding mode and at count
value
5.2.13 Duration of the timed signal of output 2
(only if a timed signal has been
programmed in 5.2.12)
The duration can be set be-
tween 0.01 sec. and 99.99 sec.
A 0.00 setting is not accepted
5.2.14 End of programming
Programming is carried out
once more. The values input
can be checked and modified.
Programming is complete and
the values input are taken over
as new parameters.
Then the device is ready for op-
eration.
5.3 Speed indicator / frequency meter mode
setting
In the speed indicator / frequency meter mode, in-
puts INP B, RESET and GATE have no function.
5.3.1 Polarity of the inputs
npn: switching to 0 V
pnp: switching to +24 V
8
preset 2 in adding
preset 2 in adding mode and
0 in subtract-
0 in subtracting mode
5.3.2 Activation of the 30 Hz filter
0 in
5.3.3 Setting of the scale factor
preset
5.3.4 Decimal point setting
5.3.5 Display mode
5.3.6 Maximum pulse waiting time
This value indicates the time during which the de-
vice will wait for a pulse before displaying a 0
speed.
Values below 1.1 sec. are ignored and set auto-
matically to 1.1 sec.
max. counting frequency: 20
kHz
max. counting frequency: 30 Hz
Scale factor setting range from
00.0001 to 99.9999. Fixed deci-
mal point set to 4 decimal
places.
A "0" setting is not accepted.
The decimal point determines
the number of decimal places
displayed. It is only used for dis-
playing purposes and has no in-
fluence on the counting.
0
no decimal place
0.0
one decimal place
0.00
two decimal places
0.000
three decimal places
Conversion and display of the
frequency / speed in 1/sec.
Conversion and display of the
frequency / speed in 1/min.
Maximum delay 01.1 sec. (mini-
mum value)
Maximum delay 99.9 sec.
Publicité
