Kübler Codix 717 Notice De Mise En Service page 17

5.1.6 Decimal point setting
The decimal point determines
the number of decimal places
displayed. It is only used for dis-
playing purposes and has no in-
fluence on the counting.
0
0.0
0.00
0.000
5.1.7 Resetting mode
Manual (using the red push-but-
ton) and electrical resetting
No resetting possible (red push-
button and reset input idle)
Only electrical resetting
Only manual resetting
5.1.8 Preset 1
Preset 1 activated
Preset 1 disactivated and with-
out function
5.1.9 Shape of output 1
(only if preset 1 is activated)
Permanent signal of output 1,
activated at count value
set 1 in adding mode and at
count value
tracting mode
Permanent signal of output 1,
will become passive at count
value
mode and at count value
set 1 in subtracting mode
Timed signal of output 1 will
become passive at count value
preset 1 in adding mode and
at count value
subtracting mode
no decimal place
one decimal place
two decimal places
three decimal places
pre-
preset 1 in sub-
preset 1 in adding
pre-
preset 1 in
Timed signal of output 1 is
activated at count value
set 1 in adding mode and at
count value
tracting mode
5.1.10 Duration of the transient output 1 (only
if a timed signal has been programmed in 5.1.9)
The duration can be set be-
tween 0.01 sec. and 99.99 sec.
A 0.00 setting is not accepted
5.1.11 Shape of output signal 2
Permanent signal of output
2, activated at count value
preset 2 in adding mode and
at count value
ing mode
Permanent signal of output
2, will become passive at
count value
adding mode and at count
value
Timed signal of output 2 will
become passive at count
value
mode and at count value
in subtracting mode
Timed signal of output 2 is
activated at count value
preset 2 in adding mode and
at count value
ing mode
5.1.12 Duration of the timed signal of output 2
(only if a timed signal has been
programmed in 5.1.11)
The duration can be set be-
tween 0.01 sec. and 99.99 sec.
A 0.00 setting is not accepted
pre-
preset 1 in sub-
0 in subtract-
preset 2 in
0 in subtracting mode
preset 2 in adding
0
0 in subtract-
5