Kübler Codix 717 Notice De Mise En Service page 19

5.2.5 Operation of the GATE input
Counting runs when the GATE
input is OFF.
Counting runs when the GATE
input is ON.
5.2.6 Counting unit
Counting unit: seconds (the
setting of the decimal point de-
termines the resolution).
Counting unit: minutes (the
setting of the decimal point de-
termines the resolution).
Counting unit: hours (the set-
ting of the decimal point deter-
mines the resolution).
Counting unit:
hours:minutes:seconds (the
setting of the decimal point is
ignored).
5.2.7 Decimal point setting
The decimal point determines the
number of decimal places dis-
played. It is only used for display-
ing purposes and has no
influence on the counting.
0
0.0
0.00
0.000
5.2.8 Resetting mode
Manual (using the red push-but-
ton) and electrical resetting
No resetting possible (red push-
button and reset input idle)
Only electrical resetting
Only manual resetting
no decimal place
one decimal place
two decimal places
three decimal places
5.2.9 Preset 1
Preset 1 activated
Preset 1 disactivated and with-
out function
5.2.10 Shape of output 1
(only if preset 1 is activated)
Permanent signal of output 1,
activated at count value
set 1 in adding mode and at
count value
tracting mode
Permanent signal of output 1,
will become passive at count
value
mode and at count value
preset 1 in subtracting mode
Timed signal of output 1 will
become passive at count value
preset 1 in adding mode
and at count value
in subtracting mode
Timed signal of output 1 is
activated at count value
set 1 in adding mode and at
count value
tracting mode
5.2.11 Duration of the timed signal of output 1
(only if a timed signal has been
programmed in 5.2.10)
The duration can be set be-
tween 0.01 sec. and 99.99 sec.
A 0.00 setting is not accepted
5.2.12 Shape of output signal 2
Permanent signal of output 2,
activated at count value
set 2 in adding mode and at
count value
mode
pre-
preset 1 in sub-
preset 1 in adding
preset 1
pre-
preset 1 in sub-
pre-
0 in subtracting
7