Network Option - MSA Galaxy Manuel D'instructions

Figure 2-7. Memory Card Option

Network Option

The Galaxy Automated Test System supports two different network
options:
• Wired (10 base-T) or
• Wireless (802.11b).
These options allow for remote data access and/or use of a local receipt
printer.
• Check that the four white tubing plugs are in place in the ports on
the right-hand side of the Test Stand before connecting the
Network Interface module.
• Only install (or remove) the Network Interface with the power cord
removed from the "MASTER" or rightmost Test Stand.
• If the Network Interface will be installed on an existing network,
please contact a Network Administrator to perform the rest of the
setup.
• Each Network Interface is shipped from MSA with the following
factory defaults (these factory defaults can also be recovered by
using the Network Reset command from the Test Stand):
• Wired Interface (radio will be turned OFF on wireless units)
• IP: 192.168.0.100
• To alter these settings, connection must first be made to the
Network Interface. This can be done using any web browser with
2-9