Memory Card Option; Warning - MSA Galaxy Manuel D'instructions

The AC power module and the battery pack must not be
used together. Only one of these may be used at a time. The
simultaneous use of both may cause unexpected and unde-
tectable drain of the cells within the battery pack.
1. Insert four alkaline AA cells into the battery compartment; observe
proper polarity as indicated on the cell holder.
2. Install the alkaline battery hold-down strap.
3. Check that the four white tubing plugs are in place in the ports on
the right-hand side of the Test Stand.
4. Plug the battery pack into the side of the Test Stand as shown in
FIGURE 2-6.

Memory Card Option

1 Ensure that memory card is not write-protected or locked.
2. Plug in the memory card (FIGURE 2-7).
3. Check that the four white tubing plugs are in place in the ports on
the right-hand side of the Test Stand.
4. Install the protective end cap.
5. Shared Memory Card: When using a memory card with multiple
connected Test Stands, the memory card must be placed in the
"MASTER" or rightmost Test Stand.
a. Verify Test Stand connections by looking for status indications
(+ or -) in the right and/or left corner of the Test Stand display
while waiting for the "INSERT INSTRUMENT" display.
• A plus (+) indicates that a good connection was made to
the Test Stand located on that side.
• A minus (-) indicates that no Test Stand was found on that
side.
• Proper shared memory card operation will not occur unless
all Test Stands are communicating properly.
2-8

" WARNING