Cleanmaxx PC-P011E Mode D'emploi page 22

EN
Cleaning the Dust Container, HEPA Filter, Dust Filter and Filter Holder
1. Pull out the HEPA fi lter (5) by the handle.
2. Reach into the dust container and pull out the dust fi lter (4) with the fi lter holder (3).
3. Twist the dust fi lter anticlockwise and pull it out of the fi lter holder (Picture B1).
4. Tap out all parts and clean them with a soft brush if necessary.
5. The fi lter holder and dust fi lter can also be rinsed with clear water.
NOTICE: Do not wet-clean the HEPA fi lter!
6. Wipe out the dust container with a damp cloth if necessary.
Let all parts dry completely in the air before you reassemble them. NOTICE: Never
assemble wet or damp components or attach them to the motor unit (F)!
Assembly
1. Insert the dust fi lter into the fi lter holder and twist it clockwise until it fi ts securely
(Picture B2).
2. Insert the fi lter holder with dust fi lter into the dust container so that the two recesses fi t
directly above one another (Picture C). The fi lter holder must fi t correctly in the dust
container, it must not stick out at the top.
3. Place the HEPA fi lter on top of the dust fi lter.
4. Insert the dust container back into the motor unit (see the "Assembly" chapter – "Re-
moving / Inserting the Dust Container").
Cleaning the Motor Unit, Extension Tube and Nozzles
• Wipe down the motor unit (F), extension tube (G) and nozzles with a damp, soft cloth
if necessary. Then dry with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
Cleaning the Electric Floor Nozzle
To make it easier to clean, the brush can be removed from the electric fl oor nozzle (I):
1. Slide the latch fastener on the bottom of the electric fl oor nozzle towards the small
wheel on the electric fl oor nozzle (Picture D1).
2. Open the latch and remove (Picture D2).
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end with the star-shaped recess.
5. Insert the latch and slide the latch fastener back in place.
Storage
• Store the device in a cool, dry place which is protected from direct sunlight and is out
of the reach of children and animals.
• For easy storage and to save space, the brush nozzle (A) and crevice nozzle (H) can
be secured to the holder for the brush and crevice nozzle (B) on the extension tube
(G) (Picture E).
• For easy storage, hang with the suction opening (11) downwards into the wall bracket
(C) that is also supplied.
If the device is not going to be used for a prolonged period, remove the battery
(D) to be on the safe side: Flip up the small clip on the bottom of the battery and
pull out the battery downwards (Picture F). To prevent a deep discharge of the
battery, charge it up from time to time if it is not used for a prolonged period.
09196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 22 09196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 22
22
22.05.2019 12:09:58 22.05.2019 12:09:58