Ergomotion e Serie Manuel Du Propriétaire page 22

e9/e6 headboard bracket installation guide (optional)
For Series e9/e6 only. The e6 Headboard Brackets are an optional accessory and are not included.
A 9/16" (14 mm) & 1/2" (13 mm) socket and crescent wrench are necessary to complete installation.
Headboard Bracket (2)
STEP 1
a.) Align the hole in the bracket to the brass sleeve into
which the leg threads . Hold the bracket in place and
screw the leg into the base until it is snug . DO NOT
OVERTIGHTEN . Too much force may cause the leg
to spin freely .
b) Align the tab with the hole in the frame (located
towards the foot of the base) and use a short bolt
and nut to secure the bracket . Make sure the bolt is
tight .
STEP 3
You may now connect your headboard to the attachment plates using the remaining short bolts and nuts to
secure it to the brackets . The heads of the bolts will face outward . Use a 9/16" (14mm) socket and 1/2" (13mm)
wrench to tighten the bolts .
20
See page 21 for e5/e4+ optional Headboard Bracket installation.
HEADBOARD BRACKET COMPONENTS
T-Bracket (2) Spacer (2) Long Bolt (8)
STEP 2
Attach the plastic spacer and T-Bracket .
a.) Measure the distance between the mounting
holes on the headboard and install the spacer and
attachment plate to accommodate the headboard .
b.) To install the plastic spacer and attachment plate,
you will need (2) long bolts and (2) nuts . Place the
spacer and attachment plate in the desired location
and slip the bolts through the holes with the head
of the bolt facing outward . Position the bolts
diagonally on the spacer . Use the 9/16" (14 mm)
socket and wrench to tighten the bolts .
Short Bolt (10) Nut (18)