Ergomotion e Serie Manuel Du Propriétaire page 15

installation guide
STEP 6
Uncoil the Power Cord and connect to the Power Supply .
Place Power Supply on the ground and extend from
the base .
Ensure that the Power Supply and all attached cords are
directed toward the desired surge protector .
STEP 7
Carefully flip the base over on to its legs .
Important: Two people are required to move the bed
base. Do not drag across the floor. Do not rest frame
on its side, excessive pressure may damage the legs.
STEP 8
Plug the base into a power source . A surge protector is
strongly recommended .
Always use two people when setting up the base
STEP 9
Ensure that batteries are
correctly installed .
Quickly test functions to verify
proper setup before placing
mattress on base . Use remote
to return the base to a flat
position .
STEP 10
Locate the mattress retainer bar brackets .
Slide the left side of the mattress retainer bar into the
bracket . Pull the retainer bar to the opposite bracket
and secure the right side .
Basic setup is now complete! See page 14-19 for remote
control operating instructions.
13