Fein ASCM18QM Serie Mode D'emploi page 20

OBJ_BUCH-0000000271-001.book Page 20 Wednesday, December 21, 2016 1:15 PM
en
20
Switching on and off (figure 14).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Illumination (figure 15).
Never look or stare into the
WARNING
light of the power tool's lamp
from a short distance. Never point the light of
the lamp into the eyes of other persons in
close vicinity. The radiation produced by the
lamp can be harmful for the eye.
When pressing the On/Off switch, the light is
switched on.
After releasing the On/Off switch, the light
briefly stays on and then switches off auto-
matically.
Fig. 14
1.
2.
On/Off switch
Fig. 15
=
=