Tineco FLOOR ONE S5 COMBO Serie Mode D'emploi page 28

Usage of Hand Vac
1.Install the dustbin to the main body properly
and it clicks into place.
Fig.C-12
2.Attach the accessory tool onto the dustbin, it
will click into position when correctly fitted.
Fig.C-13
• Press the release button to remove the dustbin.
• Pull out the mesh filter as above and empty the
contents.
• Press the HEPA lock button to take out the
HEPA and sponge filter, clean both parts with
the cleaning tool.
Fig.C-14
Note:
• Clean the dustbin and filters after each use.
• To maintain high performance, wash and dry
the sponge filter monthly, replacing it every
6 months. Wash and dry the HEPA filter every
3 months, replacing it every 12 months.
• Air dry completely before reinstalling.
Runtime
• The runtime for the Floor Washer is about
15~20 minutes.
• The runtime for the Hand Vac is about
25~50 minutes.
• Estimated runtime data was obtained by a
Tineco Laboratory.
Charging Time
• A full charge takes approximately 3~4 hours.
• Estimated data was obtained by a Tineco
Laboratory using ambient temperatures
between 39.2°F (4°C) to 104°F (40°C).
Indicator
When in Use
Battery level ＞ 10%: battery
indicator will be illuminated.
Battery level ≤ 10%: battery
indicator will be blinking.
Off: no power detected or
possible battery malfunction.
Indicator blinking: dirt sensor
malfunction or blocked.
Indicator blinking: CWT is
empty.
Indicator blinking: DWT is full
or channel has a blockage.
Indicator blinking: brush
roller is not installed or has a
blockage.
Illuminated: WiFi has
successfully connected.
Blinking: WiFi is connecting.
Off: WiFi is not connected,
please connect to the network.
Indicator blinking: appliance is
in need of self-cleaning.
26